Step 1: Power off your Galaxy S6 and take out the SIM card tray.

Remember to pop up your S6 SIM card tray with an ejector pin or tweezers before we start the Galaxy S6 screen disassembly.

Step 2: Dispatch the Samsung Galaxy S6 back cover.

● To remove the S6 back panel, you should firstly use a heavy duty suction cup to slip in an opening pick or a hair dryer to heat up the S6 back cover part.

Tips: The nasty adhesive is rock-solid and tight fit within the frame, making hard to open the Galaxy S6 device. In hence, you should handle this part carefully to avoid any damage to the phone.

Step 3: Peel up the Galaxy S6 adhesive to find the screws and remove them.

● The adhesive stayed globbed to the S6 midframe, hiding the screws, so you have to clean the adhesive at first. Then remove the 13 screws securing the midframe.

Step 4: Remove the Samsung Galaxy S6 rear panel.

● Push an opening picks into the gap between the rear panel and Galaxy S6 LCD display assembly, and then remove the Galaxy S6’s rear housing.

● The Galaxy S6 rear panel is removed.

Step 5: Remove the Samsung Galaxy S6 battery.

●After disconnecting the battery connector, you can push an opening pick straight into the gap between the battery and Galaxy S6 display assembly and cut the adhesive holding the battery. Later, take out the battery.

Note: Removing the S6 battery is easier than S6 Edge’s, for the Galaxy S6 sports a flat-screen design.

Step 6: Disconnect several connectors on the Samsung S6 motherboard.

● With the help of spudger tool or case opening tool, you can disconnect the motherboard connectors easily.

• Disconnect both the Bluetooth and Wi-Fi antenna cable connectors at first.
• Disconnect other connectors on the Galaxy S6 motherboard.

Note: These connectors include the Galaxy S6 LCD screen assembly connector, ear speaker connector, charging port flex cable ribbon, home button cable etc.

Step 7: Remove the Samsung Galaxy S6 motherboard.

●After popping out all of connectors on the motherboard, you can easily lift off the motherboard out of the display now.

.

Step 8: Separate the Galaxy S6 frame from the S6 screen assembly.

●Insert the opening pick into the gap between the Galaxy S6 display frame and the screen assembly.

● Pry up the Samsung Galaxy S6 display frame.

●Slide the opening pick tool to separate the Samsung S6 display assembly from the frame. If possible, you can use several opening pick tools to help you finish the job.

Note: You need to handle carefully to avoid any damage to the Galaxy S6 LCD.

Step 9: The Samsung Galaxy S6 screen assembly comes free and you can replace it with a new S6 screen replacement.

●You can take a new S6 screen replacement and replace the cracked Galaxy S6 screen assembly part. Reinstall the Samsung S6 with all the above-mentioned components in reversed steps.

If you own a Galaxy S6 Edge and come across a cracked display, you can follow this guide for Samsung S6 Edge screen repair.

How to Repair a Cracked Galaxy S6 Edge Screen or Display

Is it difficult to handle DIY Galaxy 6S cracked screen repair?

According to iFixit, the Samsung Galaxy S6 earns a 4 out of 10 repairability score (10 is the easiest to repair). We recommend you replace the whole broken Samsung Galaxy S6 LCD display assembly for screen repair rather than only change the glass, for replacing the Samsung S6 glass without destroying the display is going to be very difficult.